iPhone 6/s, 7, 6/s Plus, 7 Plus Sticker Vinyl Skin + front glass
Order in for Same day dispatch.
3 in stock1 in stock1 in stock1 in stock3 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock1 in stock/
PLEASE READ THE FOLLOWING BEFORE APPLYING YOUR 3D PROTECT PRODUCT. THERE ARE VERY IMPORTANT STEPS YOU MUST FOLLOW.
This skin requires skill to apply and most of all patience. Although this is a one use product, the skin is durable and will take multiple tries to get the alignment right.
You will need:
A Hair dryer that blows hot air
- This will be used to seal and stick the skin very effectively
A sharp pointy knife.
-This will be used to gently remove the pre cut holes for logo, speakers, etc.
Applying your 3D PROTECT vinyl plastic wrap
Open the packet and take out the contents make sure that you have a hair dryer and a sharp pointy knife.
This protector will come with the back only and a cleaning cloth. If this is not the case or the protector is the wrong colour. Stop. Contact us straight away and we will rectify this ASAP.
The back of your iPhone needs to be dry, clean of dust,dirt, grease, including fingerprints. This can be done with the cleaning cloth provided. If there is extreme dirt on your iPhone you may need to use a damp cloth and dry it then go over it with the cloth.
Your device is nearly ready to apply the protector,but first you need to remove the pre cut holes on the vinyl sheet. Use your sharp knife to stab gently on the centres of the pre cut shapes and then moving your knife upwards this will remove the shape. Be careful not to cut the vinyl sheet. When all the holes are visible you will need your phone.
Take your phone and place it on a hard flat surface making sure this surface is not going to scratch the phone when it's turn on its back.
Find the top of the protector (where the camera hole is) and peel 25% of the backing paper downwards towards your body so you are facing the phone straight on. Line up everything with the phone and place it down. If you get it wrong lift it up slowly without touching the glue at anytime.
When you have been able to remove the rest of the backing paper you are ready for the hair dryer. You will need to turn your phone off for this and be careful not to over heat your phone. It doesn't require mega heat just a gentle warming.
Heat the edges of the protector that you will find won't stick very well. You need to keep pushing them on and heating motion. Be patient, be slow and careful. A few extra seconds here makes all the difference. Remember if you don't get it on the first try you can try again. The glue works with heat. But don't heat it so much you could melt it, hairdryer heat for a couple of seconds and take breaks. This shouldn't take more than 30 seconds.
Once this is done it's time to apply the top and the bottom pieces in the same manner. Line it up with the white line breaks, this is designed to be where it starts. Heat the strip and press into place. This might take a little more heat and patience.
Repeat with bottom strip.
You can now let the phone cool and apply the 3D PROTECT front screen protector. This doesn't need heat and needs to be on a cold phone. Clean the screen like before, place on a hard surface and line the protector up with the backing on so you can get an idea of how it will fit on the screen.
When you are ready you can take the backing film off and apply the screen in one motion, placing it flat and parallel with the phone. Press your finger in the middle and the air will disappear.
Feel free to contact our customer service if there's any problem.